Installation:
1. Download the ZIP file to a directory on your hard drive and change to that directory.
2. Upzip the contents to a directory on your hard drive.
3. From that drive and directory, execute the downloaded file.
4. Press <F6> when prompted in the status line with the 'Press F6 if you need to install a third party SCSI or RAID driver' message. This message appears at the beginning of Windows setup (during text-mode phase).
Note: Nothing will happen immediately after pressing F6. Setup will temporarily continue loading drivers. You will then be prompted with a screen asking you to load support for mass storage device(s).
5. Press the S key to 'Specify Additional Device'.
6. You will be prompted to 'Please insert the disk labeled Manufacturer-supplied hardware support disk into Drive A:' When prompted, insert the floppy disk containing the files extract from zip file and press ENTER.
7. After pressing ENTER, you should be presented with a list of available SCSI Adapters; it should list: Intel® 82801GR/GH SATA AHCI Controller .
8. The next screen should confirm your selected controller. Press ENTER again to continue.
9. Leave the floppy disk in the floppy drive until the system reboots. Windows setup will need to copy the files from the floppy again to the Windows installation folders. Once Windows setup has copied these files, you should then remove the floppy diskette so that Windows setup can reboot as needed.
10. During Windows setup, create a partition and file system on the RAID volume as you would on any physical disk.
